This page was last updated: March 10, 2010


The passenger's side lower rear quarter patch is tacked in place, and a small patch has been made for the area just in front of the wheelwell. Those are the only patches that are needed on that side of the car.

The driver's side needed one lower rear quarter patch.

The tail light panel needed some patching. It rusted around one tail light. If you look for the indentations, you can tell where the welds are.

I have my AAR hood, and it RULES! I like the quality, and it's lighter than I expected for a hinged hood. The springs were modified by Herb (formerly from Illinois) to work with the fiberglass hood, and they work great.


Looks good in sealer. Maybe it should have been black?

Clapton Green Metallic

After some clear coat.

After wet sanding in 400, 600, 1000, and 1500, then buffing: